Uniden DXI4560-2 English Owners Manual - Page 4

Installing the Base and Charger Note: Use only the supplied AD-0001 AC adapter for the base and AD-310 or AD-1010 for the charger. Do not use any other AC adapter. 1 Connect each AC adapter to the DC IN 9V jack and to a standard 120V AC wall outlet. To AC outlet AC adapter (supplied) Route the cord. To AC outlet To DC IN 9V AC adapter (supplied) To DC IN 9V Do not use a power outlet controlled by a wall switch. 2 Make sure that Charge the handsets the in use/ and LEDs illuminate. at least 15-20 hours. If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the charging contacts. 3 Once the handset battery packs are fully charged, use the telephone cord to connect the TEL LINE jack to a telephone wall jack. Route the cord. To telephone wall jack To TEL LINE Telephone cord (supplied) Charge both handsets at least 15 to 20 hours before you plug in the phone cord. Note: • Do not place the power cord where it creates a trip hazard or where it could become chafed and create a fire or electrical hazard. • If the telephone cord does not fit into your telephone wall jack, contact your local phone provider for assistance. Registering Handsets to the Base Whichever handset you choose to charge in the base is automatically registered to the base. Any additional handsets must also be registered to the base before you can use them. ) Be sure both handsets are fully charged. 2) One at a time, place each handset in the base. The in use/ LED on the base begins to flash, indicating the base is registering the handset. 3) Wait for at least five seconds, then pick up the handset and press [talk/flash]. If the display shows TALK, the handset is registered. If not, place the handset in the base to try again. 4) Press [end] and continue with the next handset. Note: • Once both handsets are registered, it doesn't matter which handset is placed in the base or the charger. • When you charge the handsets, the Caller ID summary screen and the HS1 name of the handset appears. Total:00 Mounting the Base on a Wall You can mount the phone on any standard telephone jack wall plate. ) Plug the AC adapter to the DC IN 9V jack. 2) Plug the AC adapter into a standard 120V AC outlet. 4 3) Plug the telephone cord into the TEL LINE jack. 4) Route the telephone cord through the molded 6 wiring channel as shown. ) Plug the telephone cord into the telephone 5 1 wall jack. 3 ) Align the mounting slots on the base with 6 the mounting posts on the wall. Then push in and down until the phone is firmly seated. 2 Note: To mount the phone directly on the wall, insert two 1 3/8 inch, #10 screws (not supplied) into the wall using anchors suitable for the wall material. Place the screws 3 /15 16 inches apart, and allow 1/8 inch free space between the wall and screw heads.