Uniden MHS75 English Owners Manual - Page 13
Channel Up - set
UPC - 050633501252
View all Uniden MHS75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Scan mode operation You can save channels into memory and then use scan mode to monitor those channels from lowest to highest. If the radio detects a signal on a channel, it stays on that channel as long as the signal is received; when the signal stops, the radio continues scanning. When it detects a signal, the radio stays on the channel until you press the Channel Up button or the signal stops. Resume scan 08 10 11 12 13 14 15 17 The radio scans about 5 channels in 0.5 seconds. Using the radio in scan mode • To activate scan mode, press Scan-Dual. • You must have at least two channels in memory to start a scan. • You cannot transmit while in scan mode. • To save a channel into memory, select the channel, then press the Mem button. The Mem icon shows on the display whenever you tune to that channel. • To remove a channel from memory, set the radio to that channel, then press the Mem button. The Mem icon no longer shows on the display. • When the radio stays on a channel, press Channel Up to leave that channel and resume scanning. • To end the scan, press the Scan-Dual button again; the radio remains on the last scanned channel. Uniden MHS75 Radio Owner's Manual E-9