Uniden SC230 English Owners Manual - Page 26
Using AC Power, Connecting the Antenna
UPC - 050633650417
View all Uniden SC230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Before you use rechargeable batteries for the first time, charge them for 14 hours to bring them to a full charge. Discharged batteries take about 14 hours to fully recharge. Using AC Power You can power the scanner using the supplied 6V, 500 mA AC adapter. To use the scanner on AC power, plug the AC adapter into a standard AC outlet. If rechargeable batteries are installed and REG. ALK. BATT./NI-MH. BATT. is set to NI-MH. BATT., the adapter powers the scanner and recharges the installed batteries at the same time. Connecting the Antenna To attach the supplied stub antenna to the connector on the top of your scanner, align the slots around the antenna's connector with the tabs on the scanner's BNC connector. Then slide the antenna's connector down over the scanner's connector and rotate the antenna connector's outer ring clockwise until it locks into place. Connecting an Optional Antenna The scanner's BNC connector makes it easy to connect a variety of optional antennas, including an external mobile antenna or outdoor base station antenna. Note: Always use 50-ohm, RG-58, or RG-8, coaxial cable to connect an outdoor antenna. If the antenna is over 50 feet from the scanner, use RG-8 low-loss dielectric coaxial cable. You can get a BNC adapter at your local electronics store. Setting Up Your Scanner 26