Uniden UC100B-DC English Owner Manual - Page 5

Compliance

Page 5 highlights

2. Drill the screw holes into the ceiling according to the drill template. 3. Route the cables and fix the mounting base on the ceiling with three screws (included). 4. Adjut surveillance angle. Loosen one tilting adjustment screw and adjust as needed. Tighten the screw. COMPLIANCE FCC PART 15 The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

5
2. Drill the screw holes into the ceiling according to the drill template.
3.
Route the cables and fix the mounting base on the ceiling with three
screws (included).
4. Adjut surveillance angle. Loosen one tilting adjustment screw and
adjust as needed. Tighten the screw.
COMPLIANCE
FCC PART 15
The equipment has been tested and found to comply with the limits
for a Class B device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by