Uniden UM435 Owner s Manual - Page 36

Installing The Hardware

Get Uniden UM435 PDF manuals and user guides View all Uniden UM435 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

INSTALLING THE HARDWARE MOUNTING THE RADIO Your radio can sit at any angle in the mounting bracket so it can easily accommodate the best location. First, determine the best place to mount the radio. For optimum performance, find a location that can: xx Properly support the weight of the radio, approximately 2.2 pounds or 1.0 kilograms. You may need to use some type of anchor with the mounting screws to hold the radio, depending on the surface. xx Keep the battery leads as short as possible. xx Keep the antenna lead-in wire as short as possible. xx Allow free air flow around the heat sink on the rear of the radio. xx Avoid interference with the ship's compass. 1. Install the radio into the mounting bracket. 2. Position the radio into the desired location. Mark the edges of the bracket on the mounting surface. Step 1: Slide the radio into the mounting bracket. Step 2: Tighten the mounting knobs to secure the radio in place. Actual product image may vary. 3. Use the mounting bracket template (included) to mark the drill holes on the mounting surface. 4. Drill the holes for the mounting bracket; be sure to follow any special requirements of the mounting surface. 5. Remove the bracket from the radio, and use the mounting hardware to secure the bracket to the mounting surface. 6. Install the radio back into the mounting bracket. 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
INSTALLING THE HARDWARE
MOUNTING THE RADIO
Your radio can sit at any angle in the mounting bracket so it can easily accommodate
the best location. First, determine the best place to mount the radio. For optimum
performance, find a location that can:
x
Properly support the weight of the radio, approximately 2.2 pounds or 1.0 kilograms.
You may need to use some type of anchor with the mounting screws to hold the radio,
depending on the surface.
x
Keep the battery leads as short as possible.
x
Keep the antenna lead-in wire as short as possible.
x
Allow free air flow around the heat sink on the rear of the radio.
x
Avoid interference with the ship’s compass.
1.
Install the radio into the mounting bracket.
2.
Position the radio into the desired location. Mark the edges of the bracket on the
mounting surface.
Step 2:
Tighten the mounting
knobs to secure the
radio in place.
Actual product image may vary.
Step 1:
Slide the radio into
the mounting bracket.
3.
Use the mounting bracket template (included) to mark the drill holes on the mounting
surface.
4.
Drill the holes for the mounting bracket; be sure to follow any special requirements of
the mounting surface.
5.
Remove the bracket from the radio, and use the mounting hardware to secure the
bracket to the mounting surface.
6.
Install the radio back into the mounting bracket.
28