Uniden XCA555 English Owners Manual - Page 16

Low Battery Indicator When the Battery Pack in the Handset is very low and needs to be charged, the TALK/BATT LOW LED flashes. If the TALK/BATT LOW LED begins flashing, the phone is programmed to eliminate its functions to save power. The table below describes what to do to return your phone to normal operation. During a Call In Standby Mode Only the T button operates. None of the buttons will operate. The Handset beeps and The Handset TALK/BATT the TALK/BATT LOW LED LOW LED flashes once flashes once every 3 every 3 seconds. seconds. Complete your call as You will not be able to quickly as possible. make a call. Return the Handset to the Base Unit for charging. Return the Handset to the Base Unit for charging. Setting the Handset Listening Volume You can choose two different volume settings when using the Handset during a call. When the Handset is first used, the volume will be at its normal setting. However, you can change to a higher volume by pressing V during a call. To return to the normal volume, press V again. Setting Handset Ringer Volume You can choose between two different ringer styles, each with a high and low volume. To select the style and volume you like best, press the G key until you hear the desired setting. Note: Just remember to select your Hanset ringer style and volume when you're not using the phone for a call. Setting the Base Ringer Volume (XCA555 Only) To adjust the Base Unit ringer volume, set the ring vol-off lo hi switch to the desired setting. ring vol OFF-LO-HI Note: Allow 15 to 20 hours without any interruption for the Handset to fully recharge. Setting the Pulse/Tone Switch Be sure the pulse-tone switch is in the tone position. pulse-tone Note: Most phone systems are Tone dialing. Check with your local phone company if you are not sure whether your system is Tone or Pulse dialing. 16 XCA550/55