RoboSHOT HD Cameras
RoboSHOT HD Cameras - Document Number 342-0795 Rev A
Page 26 of 44
G
ENERAL
S
PECIFICATIONS
Function
Description
Part Numbers
RoboSHOT 12 QDVI System, 999-9906-000 (North America), 999-9906-001 (Int’l)
RoboSHOT 30 QDVI System, 999-9916-000 (North America), 999-9916-001 (Int’l)
Image Device
1/2.8-Type Exmor CMOS Sensor
Video Resolution/Frequencies
1080p60/59.94/50/30/25, 1080i/60/59.94i/50, 720p/60/59.94/50/30/25
Vaddio Special Features
Tri-Synchronous Motion:
Concurrent PTZ motor movement and simultaneous PTZ arrival at a stored
preset
Advanced ISP:
Vivid and accurate color reproduction with extremely fast, razor sharp automatic focus
and iris routines
Video Aspect Ratio
16:9 Aspect Ratio for all resolutions
Effective Pixels
2.14 Million Effective pixels
2.38 Million Total Pixels
RoboSHOT 12
Lens and Horizontal FOV
12X Optical Zoom, Super Wide Mode:
73.0° (wide) to 6.6° (tele),f=3.91mm to 47.0mm,
F1.8 to F3.4
10X Optical Zoom, Normal Mode:
67.3° (wide) to 7.6° (tele),
f=3.8mm to 38.0mm,
F1.8 to F3.4
NOTE:
Default is Normal Mode
RoboSHOT 30
Lens and Horizontal FOV
30X Optical Zoom
65° (wide end) to 2.3° (tele end), F1.6 to F4.7
Minimum illumination
RoboSHOT 12
1.0 lx (F1.8, 50IRE), recommended illumination >100 lux and <100,000 lux
Minimum illumination
RoboSHOT 30
1.4 lx (F1.6, 50IRE), recommended illumination >100 lux and <100,000 lux
Minimum working distance
RoboSHOT 12
10mm (wide), 800mm (tele)
Minimum working distance
RoboSHOT 30
10mm (wide), 1.2m (tele)
S/N ratio
More than 50 dB
Sync system
Internal
White balance
Auto, ATW, Indoor, Outdoor, One-push, Manual (accessible through external control)
Gain
Auto / Manual (0 to 28 steps - accessible through external control)
Back-light compensation
On/Off (IR Remote)
Focusing system
Auto Focus / Manual Focus Mode / One Push Trigger Mode / Infinity Mode / Near Limit Mode
Noise Reduction
On/Off, 6 Steps, Off
through 5 (accessible through external control)
Aperture/Detail
16 Steps (accessible through external control)
Control Interface(s)
RS-232 API:
Modified VISCA Emulation (TTL signal level), Baud rate: 9600 bps and 38,400 bps, 1-Stop
bit. Default to 9.6 Kb/s for Cat-5e Distance
Telnet Serial Command API
Internal Web page for Network Set-up, firmware updates and network management
Vaddio IR Remote Commander
Pan & Tilt Angle/Speed
Pan/Tilt
Angles: ±160°, Tilt: +90°, -30°,
Pan/Tilt Speeds:
Both Axes 0.35°/sec to 120°/sec
Rear Panel Connectors
Network:
RJ-45 with Green & Yellow LED to show connection and usage
RS-232:
RJ-45, Carries bidirectional control to and from the camera
EZ Power Video:
RJ-45 Shielded,
carries power and differential video signals for the Quick-Connect
Cat-5 systems
Rear Panel Controls
16-Position Rotary Switch for Resolution selection
8-Position Dip Switch for IR Frequency, Image Flip, wide mode and Reset to Default Settings
Power Supply
Powered by Quick-Connect interfaces
Compatible Joystick and Video Control
Consoles
ProductionVIEW Precision Camera Controller
ProductionVIEW HD
ProductionVIEW HD MV with Integrated Multi-viewer,
ProductionVIEW HD-SDI MV with Integrated Multi-viewer
AV Bridge MATRIX PRO
Operating/Storage Temperature/Humidity
0°C (32°F) to 40°C (104°F), 20% to 80%
Mass
4.85 lbs.(2.199923 kg - Roughly 900 peanut M&Ms)
Dimensions
Small (3 dimensions not counting space/time)
6.942” (176.3mm) H x 7.056” (179.2 mm) W x 6.757” (171.6mm) D,
Quick-Connect DVI/HDMI SR
Quick-Connect System
Quick-Connect DVI/HDMI (two Cat-5e) for distances up to 100’ (30.84m)
HDMI or DVI-D and Analog Component YPbPr output with IR forwarding
Connectors
Power Connector:
5.5mm OD, 2.5mm ID coaxial connector
RJ-45:
Four (4) Control IN, Control OUT, Daisy Chain OUT, EZCamera Power Video Port
Video Output:
DE-15 connector for HD Analog Component (Y,PB,PR) video only (No SD Support)
IR Output:
Transmits modulated or non-modulated IR signals received from the HD-19 IR receiver
Video Outputs:
DVI-D (Female - Single Link) or HDMI with adapter cable (using the Recessed Color
Space Conversion Switch) , DE-15F (High Density D-Sub 15-Pin F) for HD YPbPr
Cat-5 Cable Distance
Up to 100’ (30.5m)
Power Supply
24 VDC, 2.0 Amp Switching Power Supply
Dimensions / Weight
1.6” (40.64mm ) H x 8” (203.2mm) W x 6.751” (171.45mm) D, ½-Rack Size / 1.21 lbs. (0.548846804 kg)
Accessory Options
1-RU Rack Mount Panel for two (2) units (side by side):
P/N:
998-6000-003
1m (3.3’) DVI-D Male to HDMI Male P/N:
440-5643-001
3m (10’) DVI-D Male to HDMI Male P/N:
440-5643-003