Vantec UGT-ST622 User Guide - Page 7
Hardware Installation
 |
View all Vantec UGT-ST622 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
JP J1-J4 J5-J8 G (Jumpers Settings) Description Active Port 1-2 close Enable SATA Connector A 2-3 close Enable SATA Connector D 1-2 close Enable SATA Connector B 2-3 close Enable SATA Connector C 2.2 Hardware Installation 1. Turn off the power to your computer. 2. Unplug the power cord and remove your computer's cover. 3. Remove the slot bracket from an available PCIe slot. 4. To install the board, carefully align the card's bus connector with the selected PCIe slot on the motherboard. Push the board down firmly. 5. Attach your internal devices to the SATA 6G PCIe Card. 6. Replace the slot bracket's holding screw to secure the card. 7. Replace the computer cover and reconnect the power cord. UGT-ST622 Page 7
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13
 |
 |
UGT-ST622
Page 7
G (Jumpers Settings)
JP
Description
Active Port
J1-J4
1-2 close
Enable SATA Connector A
2-3 close
Enable SATA Connector D
J5-J8
1-2 close
Enable SATA Connector B
2-3 close
Enable SATA Connector C
2.2 Hardware Installation
1.
Turn off the power to your computer.
2.
Unplug the power cord and remove your computer
’
s cover.
3.
Remove the slot bracket from an available PCIe slot.
4.
To install the board, carefully align the card
’
s bus connector with
the selected PCIe slot on the motherboard. Push the board down
firmly.
5.
Attach your internal devices to the SATA 6G PCIe Card.
6.
Replace the slot bracket
’
s holding screw to secure the card.
7.
Replace the computer cover and reconnect the power cord.