Viking AD51620 Outdoor Kitchen Planning Guide - Page 16

WHEN TO USE INSIDE AND OUTSIDE FILLER STRIPS TOGETHER (SEE SAMPLE DRAWING BELOW) In situations where the back of your cabinet layout is exposed, such as in an island setting, inside and outside filler strips will need to be used. Use a 90° (VCF90) or 135° (VCF135) inside filler whenever you have a 90 or 135 degree turn. Depending on which turn you are accounting for, a 90° (VOCF90) or 135° (VOCF135) outer corner back panel assembly must be used to complete the layout. These assemblies consist of a 4"W. stainless steel "post", two mounting brackets, and two stainless steel back panels. The post is placed in the middle corner of the void area (see diagram below) and the back panels are attached to it. The post gives support to the void area underneath the countertop that falls in between the cabinets. Next, the supplied brackets are attached to the inside of the two adjacent cabinets in the run. The stainless steel back panels are then attached to the brackets and fit flush with the back panels attached to the back of the cabinets to the right and left of the center post. VSP30 VOCF90 Back Panel VBP18 VBP16 VBPFLR4 VBP41 VOCF90 Back Panel VBO1811 VBBO1601 VQBO4121 VOCF90 VFLR4 VCF90 VBO1830 VSP30 VSP30 VBP18 16