Viking RDSCG2305BSS Use and Care Manual - Page 22
Door Replacement and Adjustment, Troubleshooting
View all Viking RDSCG2305BSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Product Care Door Replacement and Adjustment 1 2 Reinstall door to range. 3 2 1 2 3 Open door completely. Reinstall hinge trim on both sides. 4 Remove pins from holes in hinges. 5 Close door. If the door needs to be adjusted, loosen hinge trim screws located in step 2. Adjust the screws located between the door and kickplate using a 5/32" hex head allen wrench. After adjustment, tighten hinge trim screws. 42 Troubleshooting Problem Range will not function. Broil does not work. Oven does not operate in self-clean. Oven is not clean after selfclean cycle. Oven light will not work. Igniters will not work. Igniters sparking but no flame ignition. Igniters sparking continuously after flame ignition. Burner ignites but flame is large, distorted, or yellow. Strong odor and/or smoke is noticed first few times oven is used. Oven indicator light on; oven will not heat Possible Cause and/or Remedy Range is not connected to electrical power: Have electrician check power circuit breaker, wiring, and fuses. Temperature control knob is rotated too far past broil position. Door is not shut tight enough for automatic door latch to lock. Temperature control knob not rotated all the way past clean until it stops. Light bulb is burned out. Range is not connected to power. Circuit is tripped. Fuse is blown. Range is not connected to power. Gas supply valve is in "OFF" position. Gas supply is interrupted. Power supply is not grounded. Power supply polarity is reversed. Igniters are wet or dirty. Burner ports are clogged. Unit is being operated on wrong type of gas. Air shutters not properly adjusted. This is normal burn off of insulation and protective oils in oven. This will go away after using oven a few times. Oven is operating properly. Unit will resume heating function once it has cooled. 43 Product Care