Viking RVDD336R Installation Instructions - Page 2
Interior Blower Installation, Exterior Blower Installation, All Units - appliances
View all Viking RVDD336R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
VIKING RANGE, LLC PLANNING Interior Blower Installation Downdraft Ventilators Exterior Blower Installation This downdraft blower system is designed to be used to exhaust airborne contaminants when cooking with a variety of gas or electric cooktops. It can be mounted in island, peninsula, or conventional wall locations. This unit can be easily installed following these basic steps: • Cut out the countertop opening. • Mount the unit in the cabinet. TYPICAL INSTALLATION COUNTER CHIMNEY TOP TOP COOK TOP GEAR MOTOR COVER BLOWER BOX AIR VENT 120 VAC GROUNDED OUTLET • Install the Model VIDV500 Interior Blower • Connect the ductwork and electrical. • Install the cooktop. Note: the high level of air flow of this appliance may effect the gas flame on some types of gas cooktops. This is NORMAL and will cause no harm, but can be corrected by lowering the speed of the blower. 3-1/4" X 10" DUCT CONNECTOR ELECTRICAL SPECIFICATIONS 120 VAC • 60 Hz • 4.0 A This downdraft blower system is designed to be used to exhaust airborne contaminants when cooking with a variety of gas or electric cooktops. It can be mounted in island, peninsula, or conventional wall locations. TYPICAL INSTALLATION COUNTER TOP CHIMNEY TOP COOK TOP GEARMOTOR COVER AIR VENT This unit can be easily installed following these basic steps: • Cut out the countertop opening. • Mount the unit in the cabinet. 10" ROUND DISCHARGE PLATE 120 VAC GROUNDED OUTLET • Install 10" round discharge plate 10" ROUND DUCTWORK • Install Model VEDV900 or VEDV1200 (DIPR151RSS only) External Blower ELECTRICAL • Connect the ductwork and electrical. SPECIFICATIONS 120 VAC • 60 Hz • 6.0 A (max.) • Install the cooktop. Note: the high level of air flow of this appliance may effect the gas flame on some types of gas cooktops. This is NORMAL and will cause no harm, but can be corrected by lowering the speed of the blower. TAKE MEASUREMENTS All Units 1. Refer to the cooktop installation instructions for dimensions of cooktop, countertop cut-out, and cabinet requirements. The Model RVDD330R / CRVDD330R will fit in most 30" wide cabinets, the Model RVDD336R / CRVDD336R will fit in most 36" wide cabinets, and the Model RVDD345R / CRVDD345R will fit most 45" wide cabinets. However, it is recommended that oversized cabinets be used for easier installation. 2. Cooktop depth can vary greatly from one to another. This may cause the fit of these two appliances to be rather tight. Pay special attention to the areas of potential interference highlighted above. A countertop with (A) a raised lip and/or (B) a backsplash may not allow enough flat countertop for a proper installation. Note that 2" of flat countertop is required behind cooktop and that 1-3/4" is necessary between the back edge of the cooktop and the inside of cabinet back. 2