Viking RVDD336R Installation Instructions - Page 8
Install Electrical Wiring, Install Cooktop
View all Viking RVDD336R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
VIKING RANGE, LLC Downdraft Ventilators INSTALL ELECTRICAL WIRING Interior Blower Installation Exterior Blower Installation ! CAUTION: All electrical wiring should be done by a qualified person(s) in accordance with all applicable codes and standards. 1. Mount a standard wiring box, with 3-pronged receptacle, inside the cabinet. Make sure the downdraft's power cord can easily reach it. 2. Run appropriate power cable into cabinet and connect it to receptacle. 3. Plug the downdraft's power cord into the outlet. Make sure that the power cord is routed away from the heat generated by the cooktop. INSTALL COOKTOP All Units 1. Align the cooktop with the downdraft and fasten cooktop in place. Note: Accurate alignment of cooktop and downdraft is necessary to ensure that there is no interference when air vent is raised and lowered.There should be a gap of 1/32" - 1/16" between the back of the cooktop and the front of the downdraft cover. ! CAUTION: All electrical wiring should be done by a qualified person(s) in accordance with all applicable codes and standards. 1. Mount a standard wiring box, with 3-pronged grounded receptacle, inside the kitchen cabinet. Make sure the downdraft's power cord can easily reach it. 2. Run appropriate power cabinet into cabinet and connect it to electrical box and receptacle. 3. Exterior blower may not exceed 6.0 Amp rating. 4. Run 2-wire plus ground power cable from the remote blower to wiring box on 10" round discharge plate. 5. Connect downdraft wiring to power cable from remote blower. Wire black to black, white to white, and green to green or bare wire. 6. Replace wiring box cover. 7. Plug the downdraft's power cord into outlet. Make sure that the power cord is routed away from the heat generated by the cooktop. "R" MODEL DOWNDRAFT REMOTE CONTROL COUNTERTOP Note: The downdraft remote control must be mounted into the countertop, at least 4" from cook top or range top edge. 8