Viking RVMHC Installation Instructions - Page 6

figure Ventilation System (Preparing Oven for Installation) Fan Cover Bracket (C) Vertical Exhaust: Outside Ventilation • Remove and save 4 screws and fan cover bracket as shown in figure 5. Withdraw hood fan unit. See figure 6. figure figure figure figurfiegure figure figure figure figufriegure figure HORIZONTAL EXHAUST: Replace the fan cover bracket. Make sure the fan blades are visible through the rear openings in the oven before proceeding. Attach fan cover bracket to unit with 4 screws. The hood fan unit is now rotated for horizontal exhaust operation. Exhaust Damper Assembly HORIZONTAL EXHAUST: Attach the Exhaust Damper Assembly to the back of the mounting plate by sliding it into the slits in the same direction as the arrow. Using Tapping Screw 4x12 from the INSTALLATION HARDWARE, tighten into place. figure figure figure (A) Rotate 90˚ VERTICAL EXHAUST: Rotate hood fan unit 90˚ so that the fan blade openings are facing the top of the oven. Replace hood fan unit into oven unit. • Put the lead wire into the box. • Replace the fan cover bracket. If the cover does not fit properly, the hood fan unit is improperly placed. Follow the steps in figure ! again. • Attach the fan cover bracket to the oven unit. Exhaust Damper Assembly figure figure figufriegure figure figure (A) VERTICAL EXHAUST: Attach the Exhaust Damper Assembly to the fan cover on the top of the outercase cabinet by sliding it into the slits in the same direction as the arrow mark. Tapping Screw 4x12 from the INSTALLATION HARDWARE, tighten into place. (B) E5 figure figure igure figure iregure figure