Viking VCWB301R Installation Instructions - Page 14
Home Security System Connection, Securing Your Wine Cellar
![]() |
View all Viking VCWB301R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Home Security System Connection NOTE: Contact a qualified electrician or authorized agent from alarm company to connect your home security system to the wine cellar. Home security system connection must be hooked up before the unit is installed. 1. Remove the four mounting screws attaching the unit compartment cover to the cabinet. (2 per side) 2. Remove the grille louver assembly to access the black safety grille. 3. Turn power off. 4. Remove the four screws that attach the top grille assembly to the mounting brackets. 5. Remove the 3 screws at the right side of the unit that attach the safety grille to the compartment cover. 6. Choose the desired switching position and connect according to alarm system requirements. 7. Replace the unit compartment cover. The home security system will be activated if temperatures in the wine cellar fluctuate outside of the set point by 5° for and extended time period. Red, white, and black wiring* *Black = common Red = normally closed White = normally open Back side of wine cellar 26 Securing Your Wine Cellar (3 options) WARNING ELECTRICAL SHOCK HAZARD Disconnect power at breaker or turn power disconnect switch to OFF position before performing any installation procedure. Failure to do so can result in death or electrical shock. OPTION 1 If a solid soffit is 1" (2.5 cm) or less above the wine cellar, anti-tip boards are not required. To secure the wine cellar raise unit until compartment is firmly seated under the soffit. OPTION 2 If a solid soffit is not available or soffit is more than 1" (2.5 cm) above wine cellar, center wood boards on rear wall 1/4" (0.6 cm) maximum above wine cellar. Attach wood boards to wall studs with six of the provided wood screws, making sure that screws are engaged in wall studs 1-1/2" (3.8 cm) minimum and that boards extend 2" (5.0 cm) minimum over the top rear of wine cellar compressor cover. To secure the wine cellar, raise unit until compartment is firmly seated under the anti-tip board. OPTION 3 Position the wood block over the unit and secure it to wall studs using eight of the provided wood screws and "L" brackets. Make sure screws extend a minimum of 1" (2.5 cm) into each of the two wall studs. The wood block must extend a minimum of 3" (7.6 cm) over the unit. To secure the wine cellar, raise unit until compartment is firmly seated under the anti-tip boards. Solid Soffit 1" (2.5 cm) or less OPTION 1 1/4" (0.6 cm) maximum OPTION 2 Two 2 x 4 boards attached to wall with six wood screws (minimum) 1/4" (0.6 cm) maximum 3" (7.6 cm) minimum OPTION 3 "L" bracket with (4) screws on each end. (1) 2x4 attached to both "L" brackets minimum of 1" (2.5 cm) screws. Screws extend minimum of 1" (2.5 cm) into each wall stud. Rear Wall 2" (5.0 cm) minimum 27
![](/manual_guide/products/viking-vcwb301r-installation-instructions-2d4563b/14.png)