Viking VCWB301R Installation Instructions - Page 15
Securing Your Wine Cellar, Kickplate Installation
![]() |
View all Viking VCWB301R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Securing Your Wine Cellar Before moving the wine cellar in place, confirm the finished dimensions, electrical location, minimum door and shelf clearances, and door panel instructions. 1. Position wine cellar in front of cutout. 2. Verify operation by plugging power cord in receptacle. Power switch will be shipped in the "ON" position and showroom switch will be in the "OFF" position. (If showroom switch is switched to the "ON" position, showroom mode is engaged and power is shut-off to the compressor. This mode is for showroom display only). 3. Roll wine cellar into cutout to within 3" (7.6 cm) of being flush with cabinets. To avoid kitchen cabinet damage, place cardboard between cabinets and wine cellar. Push cardboard back with wine cellar and remove cardboard when wine cellar is in place. Power ON/OFF Switch Showroom Switch 4. Lift the wine cellar off the rollers, adjust to desired height and level wine cellar by using a 5/16" hex head wrench. (Refer to Figure at the right) a) To raise/lower right side rear, rotate the right side rear hex rod. b) To raise/lower the left side rear, rotate the DETAIL "A" LEFT SIDE FRONT REAR DETAIL "B" RIGHT SIDE FRONT REAR left side rear hex rod. c) To raise/lower the right side front, rotate the right side front hex rod. d) To raise/lower the left side front, rotate the left side front hex rod. LEVELING LEGS LEVELING LEGS A B NOTE: DO NOT use an electric driving device. Overtightening can cause damage. VIEW SHOWN WITH KICKPLATE REMOVED 5. Align wine cellar with sides of cabinets by adjusting leveling legs. Rotate leveling legs until firmly in place against floor. 6. To secure wine cellar, raise unit until compartment cover is firmly seated under the soffit or anti-tip boards. 7. Open door. Control panel should be lit. Verify the position of the power on/off and showroom switch if there is no power to wine cellar. 28 Kickplate Installation The kickplate consists of a two (2) part assembly: one top louvered panel and one bottom solid panel. Install the kickplate with louvered section on the top. Flooring must allow the kickplate to be removed. To install: 1. Insert the bottom (solid) panel into the open end of the top (louvered) panel. The holes in the bottom panel should line up with the slots in the top panel. 2. Position the kickplate assembly along the front edge of the wine cellar. 3. Align the holes on both ends of the top (louvered ) panel with the holes in the base of the wine cellar. 4. Attach the kickplate to the wine cellar on each side with the two black phillips head screws provided. 5. Adjust the bottom (solid) panel to the desired height and fasten in place by tightening the screws in the slots. There is approximately 1" (2.5 cm) of vertical adjustment on the kickplate. Screws and slots for adjustments Attach to unit with these screws 29
![](/manual_guide/products/viking-vcwb301r-installation-instructions-2d4563b/15.png)