Viking VEDO1302SS Use and Care Manual - Page 20
Cleaning & Maintenance, Cleaning and Maintenance
![]() |
View all Viking VEDO1302SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Product Care Cleaning & Maintenance Any piece of equipment works better and lasts longer when maintained properly and kept clean. Cooking equipment is no exception. Your oven must be kept clean and maintained properly. Oven Surfaces Several different finishes have been used in your electric oven. Cleaning instructions for each surface are given below. Your oven features a Self-Clean cycle for the oven interior. See the SelfClean Cycle section in Cleaning & Maintenance for complete instructions. NEVER USE AMMONIA, STEEL WOOL PADS OR ABRASIVE CLOTHS, CLEANSERS, OVEN CLEANERS, OR ABRASIVE POWDERS. THEY CAN PERMANENTLY DAMAGE YOUR OVEN. Control Knobs MAKE SURE ALL THE CONTROL KNOBS POINT TO THE OFF POSITION BEFORE REMOVING. Pull the knobs straight off. Wash in detergent and warm water. Dry completely and replace by pushing firmly onto stem. Stainless Steel Parts All stainless steel body parts should be wiped regularly with hot soapy water at the end of each cooling period and with a liquid cleaner designed for that material when soapy water will not do the job. NOTE: It is not recommended that stainless steel cleaner be used on any surface that contains graphics, such as the control panel area. For these areas containing graphics, it is recommended to only use hot, soapy water for cleaning. Do not use steel wool, abrasive cloths, cleansers, or powders. If necessary, scrape stainless steel to remove encrusted materials, soak the area with hot towels to loosen the material, then use a wooden or nylon spatula or scraper. Do not use a metal knife, spatula, or any other metal tool to scrape stainless steel. Do not permit citrus or tomato juice to remain on stainless steel surface, as citric acid will permanently discolor stainless steel. Wipe up any spills immediately. 38 Cleaning and Maintenance Brass Parts CAUTION All special ordered brass parts are coated with an epoxy coating. DO NOT USE BRASS CLEANERS OR ABRASIVE CLEANERS ON ANY BRASS PARTS. All brass body parts should be wiped regularly with hot soapy water. When hot soapy water will not do the job, use every day household cleaners that are not abrasive. Broiler Pan and Grid Clean with detergent and hot water. For stubborn spots, use a soap-filled steel wool pad. Oven Racks Clean with detergent and hot water. Stubborn spots can be FOR YOUR SAFETY scoured with a soap-filled steel wool pad. DO NOT CLEAN THE OVEN RACKS USING THE SELF-CLEAN CYCLE. They could sustain damage due to the extreme heat of the Self-Clean cycle. The oven rack supports are designed to remain in the oven during the Self-Clean cycle. Meat Probe The meat probe may be cleaned with soap and water or a soapfilled scouring pad. Cool the probe before cleaning. Scour stubborn spots with a soap-filled scouring pad, rinse and dry. • Do not immerse the meat probe in water. • Do not store the probe in the oven. WARNING To Prevent Personal Injury Before removing the doors, make sure the pins are properly installed in the hinges. Failure to do so can result in personal injury to hands and/or fingers. WARNING Burn or Electrical Shock Hazard DANGER Make sure all controls are OFF and oven is COOL before cleaning. Failure to do so can result in burns or electrical shock. 39 Product Care
![](/manual_guide/products/viking-veso1302ss-use-care-manual-38e25c3/20.png)