Viking VIKING-DISHWASHER-NAV Installation Instructions - Page 2
IMPORTANT, Table of Contents
View all Viking VIKING-DISHWASHER-NAV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Table of Contents Warnings & Important Information 3 Dimensions & Cutout Dimensions 6 Specifications 7 General Information 8 Site Preparation 8 Water Supply 8 Drain 8 Electrical Connections 9 Hardwire Conduit Option 10 Counter Balance Spring Adjustment 12 Installation 13 Leveling 14 Final Installation 15 Performance Checklist 17 Testing for Leaks 17 Final Preparation 17 Service & Registration 18 2 IMPORTANT- Please Read and Follow • Before beginning-please read these instructions completely and carefully. • DO NOT remove permanently affixed labels, warnings, or rating plates from the dishwasher. This may void warranty or create an unsafe product. • Please observe all national and local codes. WARNING Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, hertz, and amps is attached to the product. Wiring the dishwasher with more voltage than it is rated for may cause severe damage. To reduce the risk of fire, electric shock, or injury to persons, installation work and electrical wiring must be done by qualified technician in accordance with all applicable codes and standards, including fire-rated conditions. WARNING Electrical power must be turned off at circuit breaker or fuse box before making electrical connections. Disconnect the electrical power supply and place a tag at the disconnect switch indicating that you are working on the circuit. • Please ensure that this product is properly grounded. • The installer should leave these instructions with the consumer who should retain for local inspector's use and for future reference. • The dishwasher has a factory installed backflow preventer. DO NOT add an additional check valve. • Failure to provide a 20" above floor level (50.8 cm) high loop may result in improper operation of the dishwasher. • Remove pallet screws from base. Damage could occur to dishwasher if screws are not removed. WARNING Plumbing connections must comply with applicable sanitary, safety and plumbing codes. WARNING The dishwasher door may not stay open by itself until the door panel is installed. Be aware of this when fastening the dishwasher to the cabinet. Site Preparation It is recommended that a thorough site inspection be conducted PRIOR to unpacking and moving this appliance. 3