Viking VIKING-DISHWASHER-NAV Installation Instructions - Page 6

Hardwire Conduit Option

Get Viking VIKING-DISHWASHER-NAV PDF manuals and user guides View all Viking VIKING-DISHWASHER-NAV manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Hardwire Conduit Option 1 2 3 2 1 x4 Remove any loose items in the dishwasher and carefully lay the dishwasher on its back. Note: Be careful not to pinch hoses or power cord beneath dishwasher. Remove bottom pan. Note: Rapid removal of the bottom pan will cause damage to the moisture sensor. For installation and servicing, slowly pull the bottom pan from the unit and disconnect the wire from the moisture sensor, which is located in the center of the pan. 3 4 3 1 x2 2 Remove front plate. 5 Remove factory installed power cable from terminal block. 6 Black (Line) 1 1 1 2 Attach UL approved 3/4" strain relief (not included) to bottom of terminal box. Run wires through strain relief. 10 2 White (Neutral) Connect wires to terminal block. Hardwire Conduit Option (cont.) 7 Green (Ground) 8 2 1 2 3 Connect ground wire. Tighten screws on strain relief. Note: Reinstall front plate. 3 4 x4 1 Run wire through grommet on bottom pan. Replace bottom pan. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
11
10
5
1
2
1
1
6
2
Black
(Line)
White
(Neutral)
Hardwire Conduit Option
1
3
2
x4
2
1
3
3
x2
2
1
4
Remove front plate.
Remove factory installed power
cable from terminal block.
Attach UL approved 3/4” strain relief (not included) to
bottom of terminal box. Run wires through strain relief.
Connect wires to terminal block.
Remove any loose items in the dishwasher and carefully
lay the dishwasher on its back.
Note:
Be careful not to
pinch hoses or power cord beneath dishwasher.
Remove bottom pan.
Note:
Rapid removal of the bottom pan will
cause damage to the moisture sensor. For installation and servicing,
slowly pull the bottom pan from the unit and disconnect the wire
from the moisture sensor, which is located in the center of the pan.
1
7
2
3
Green
(Ground)
2
8
1
x4
3
4
Connect ground wire. Tighten screws on strain relief.
Note:
Reinstall front plate.
Run wire through grommet on bottom pan.
Replace bottom pan.
Hardwire Conduit Option
(cont.)