Viking VIKING-DISHWASHER-NAV Installation Instructions - Page 7
Counter Balance Spring Adjustment, Installation
View all Viking VIKING-DISHWASHER-NAV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Counter Balance Spring Adjustment (if necessary) 1 2 1 1 2 2 Disconnect cable from hook. Increase tension 3 Decrease tension Set counter balance spring connector in appropriate location. Remove spring from dishwasher. 4 1 2 Reconnect cable to hook. Note: For custom panel installation, the door may require adjustment to the preload of the counterbalance springs. Follow these steps to adjust the tension. 12 Installation 1 2 2 2 1 4 x4 3 Carefully lay dishwasher on its back and attach the kick plate brackets. Screws for the brackets will already be in the base. Note: Be careful not to pinch hoses or power cord beneath dishwasher. 3 1 2 To adjust the depth of the kick plate, loosen screws on the bracket and position in the required depth. Tighten screws and repeat for other side. 4 1 1 Using tie strap attached to dishwasher, band water line, drain line, and power cord together. 5 2 x2 Attach brackets with two screws (1 per bracket). 6 1 Position unit in front of cutout. 2 Slide unit into opening; be sure to feed water, electrical and discharge lines into adjacent cabinet. 13