Viking VMDD Installation Instructions - Page 3

Unpacking your oven Electrical Requirements • Remove all packing materials from inside the oven. • Check the oven for any damage, such as misaligned or bent oven, damaged oven seals and sealing surfaces or dents inside the cavity or on the front side of the oven. If there is any damage, do not operate the oven and contact your AUTHORIZED SERVICER. Important Notes to the Installer • Read all of the Installation Guide before installing the oven. • Remove all packing material before connecting the electrical supply. • Observe all governing codes and ordinances. • Be sure to leave these instructions with the consumer. Important Notes to the Consumer Keep this manual with your Use and Care Manual for future reference. • As when using any oven generating heat, there are certain safety precautions you should follow. These are listed in the Use and Care Manual. Read all and follow carefully. • Be sure your oven is installed and grounded properly by a qualified installer or service technician. Choosing a Location Your oven can be built into a cabinet or wall by itself, above any electric wall oven, warming drawer or below a cooktop or counter. Located the electrical supply as shown in the illustrations on the following pages. The receptacle may also be located in an adjacent cabinet within reach of the power cord. A separate circuit, servicing only the appliance is required. A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation. Electrical Supply 220-240 V AC, 50 Hz Service 2800 W Power Cord 47-1/4" Note: • If you have any questions about the grounding or electrical instructions, consult a qualified electrician or service person. • Can also be installed using an electrical outlet in an adjacent cabinet within the area where the provided electrical cord can reach. • Always check electrical codes for requirements. GROUNDING INSTRUCTIONS This appliance must be grounded. The oven is equipped with a cord having a grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric current. WARNING: Improper use of the grounding plug can result in a risk of electric shock. Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the appliance. 3 E