Viper 3002 Owner Manual - Page 21
disarming
View all Viper 3002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
note: Multi-Level Security Arming only applies to a single arming cycle. Once the system is disarmed and then re-armed, all the zones will be active again. After each press of the to reach the next level of security, the remote will emit normal arm notification (1 beep and 3 flashes of the Orange LED). For easiest operation in reaching each level of security, press immediately after each notification. ➜ disarming To disarm the system, press . You will hear two chirps, and the parking lights will flash twice. If the power locks are connected to the system, the doors will unlock. If the siren chirps either four or five times when disarming, refer to the Diagnostics section of this guide. This is called Tamper Alert. The remote will indicate disarm notification with 2 beeps and 3 flashes of the Orange LED. If disarming after the system has been triggered, the remote control will send a diagnostic notification as a reminder. These diagnostic notifications are: 1. If a sensor triggered the system, the remote will beep 4-times and the Orange and Red LEDs flash 3 times. 2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the remote will beep 4-times, the Orange LED will flash 6-times and Red LED will illuminate for 3 seconds. 3. If the system was triggered so many times that NPC is active the remote will emit the above notifications with 5 beeps instead of 4. 22 © 2006 directed electronics