Viper 3002 Owner Manual - Page 26

one-time bypass

Get Viper 3002 PDF manuals and user guides View all Viper 3002 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

The in-vehicle status LED will light solidly if you are entering Valet® Mode, and it will go out if you are exiting Valet® Mode. The remote responds with the normal arm notifications with each remote button press. ➜ one-time bypass This feature stops the alarm from arming or activating any outputs that are programmed to activate when the alarm is armed. One-time bypass will defeat the following actions: Passive arming: If programmed ON the alarm will not arm itself. If the remote is used to arm the alarm after exiting the vehicle: Window roll up: If programmed ON this output will not activate. Linked Auxiliary Outputs: If programmed to activate on arm, they will not activate. To activate one-time bypass: 1. After parking turn the ignition off. 2. Turn the ignition On for more than 1-second and less than 3-seconds. 3. The siren will chirp once to indicate one-time bypass has been activated. To cancel one-time bypass perform one of the following: Arm then disarm the alarm. Turn the ignition On for more than 3-seconds. © 2006 directed electronics 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
27
© 2006 directed electronics
The in-vehicle status LED will light solidly if you are entering
Valet
®
Mode, and it will go out if you are exiting Valet
®
Mode.
The remote responds with the normal arm notifications with
each remote button press.
one-time bypass
This feature stops the alarm from arming or activating any
outputs that are programmed to activate when the alarm is
armed.
One-time bypass will defeat the following actions:
Passive arming: If programmed ON the alarm will not arm
itself.
If the remote is used to arm the alarm after exiting the vehicle:
Window roll up: If programmed ON this output will not
activate.
Linked Auxiliary Outputs: If programmed to activate on
arm, they will not activate.
To activate one-time bypass:
1.
After parking turn the ignition off.
2.
Turn the ignition On for more than 1-second and less than
3-seconds.
3.
The siren will chirp once to indicate one-time bypass has
been activated.
To cancel one-time bypass perform one of the following:
Arm then disarm the alarm.
Turn the ignition On for more than 3-seconds.
➜