Viper 480XV Owner Manual - Page 21

using your system - alarm manual

Get Viper 480XV PDF manuals and user guides View all Viper 480XV manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

remote press to select page On/Off. One beep is page On, Two beeps is page Off. When programmed off the remote will not give any notification that a page was received from the vehicle. note: If programmed Off, no alarms will be notified to the remote. Command information (armed/disarmed) will be notified to the remote. ➜ To exit programming mode The LCD remote control will exit programming mode after 5seconds of inactivity and will emit 1 long beep. using your system The buttons described in this manual correspond to the standard configuration. Remember, this is not the only way your transmitter may be set up. It can be customised to meet your needs. ➜ active arming You can activate, or arm, the system by pressing on your transmitter for one second. When the system arms, you will hear a short siren sound, or chirp, and the indicator lights will flash once. If the vehicle's central door locking has been connected to the system, the doors will lock. While the system is armed, the status LED will flash approximately once per second, indicating that the system is actively 22 © 2005 directed electronics, inc.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
22
© 2005 directed electronics, inc.
remote press
to select page On/Off. One beep is page On,
Two beeps is page Off. When programmed off the remote will not
give any notification that a page was received from the vehicle.
To exit programming mode
The LCD remote control will exit programming mode after 5-
seconds of inactivity and will emit 1 long beep.
using your system
The buttons described in this manual correspond to the standard
configuration. Remember, this is not the only way your trans-
mitter may be set up. It can be customised to meet your needs.
active arming
You can activate, or arm, the system by pressing
on your
transmitter for one second. When the system arms, you will hear
a short siren sound, or chirp, and the indicator lights will flash
once. If the vehicle’s central door locking has been connected to
the system, the doors will lock.
While the system is armed, the status LED will flash approxi-
mately once per second, indicating that the system is actively
➜
➜
note:
If programmed Off,
no alarms
will be notified to
the remote. Command information (armed/disarmed)
will be notified to the remote.