Viper 791XV Owner Manual - Page 31

valet take-over - valet button

Get Viper 791XV PDF manuals and user guides View all Viper 791XV manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

When you are ready to drive the vehicle: 1. Insert the ignition key and turn it to the ON (not the START) position. 2. Press the brake pedal. note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. While the vehicle is running during remote start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shutdown inputs: ➤ The brake pedal is pressed. ➤ The hood is opened. ➤ The shutdown toggle switch is put into the OFF position. ➤ The pre-programmed run time (12, 24, or 60 minutes) has elapsed. ➤ Transmitter button is pressed again to start the vehicle. ➜ valet take-over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. 28 © 2005 directed electronics-all rights reserved

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
28
© 2005 directed electronics—all rights reserved
When you are ready to drive the vehicle:
1.
Insert the ignition key and turn
it to the ON (not the START)
position.
2.
Press the brake pedal.
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut
down the engine if the system receives any of the following shut-
down inputs:
➤
The brake pedal is pressed.
➤
The hood is opened.
➤
The shutdown toggle switch is put into the OFF position.
➤
The pre-programmed run time (12, 24, or 60 minutes) has
elapsed.
➤
Transmitter button
is pressed again to start the vehicle.
valet take-over
The Valet Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
➜
note:
If the brake pedal is pressed before the key is in the
ON position, the engine will shut down.