Vizio VSB200 VSB200 User Manual - Page 10
Installing, alling, alling the, the Batter, Batter, Battery in the Remote Control, in the Remote - manual
UPC - 845226002373
View all Vizio VSB200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
VIZIO VSB200 User Manual Installing the Battery in the Remote Control Turn the remote control over. Press inward to release the lock (1), and at the same time, slide the battery holder out of the remote with your fingernail (2). Remove the protective plastic sheet by pulling straight out from the remote. The supplied CR2025 Lithium Button Battery should match the (+) symbol on the battery with the (+) symbol on the battery holder. Re-insert the battery cover in the same orientation. Precautionary Tips for Inserting the Batteries: Only use the specified battery. Inserting the battery incorrectly may also result in damage to the remote control. Dispose of the battery in accordance with local laws and regulations. Keep the battery away from children and pets. Remote Control Range Point the remote control at the remote control sensor to transmit the commands. Do not place any obstacles between the remote control and the receiver window. The effective range of the remote control is approximately 30 feet (10 meters) from the front of the receiver window, 30° to the left and right, 20°up and down. VIZIO Remote Control Precautions The remote control should be kept dry and away from heat sources. Avoid humidity. If the HD Sound Bar responds erratically to the remote control or does not respond at all, check the battery. If the battery is low or exhausted, replace it with a fresh battery. When not using the remote control for a long period of time, remove the batteries. Do not take the battery apart, heat it, or throw it into a fire. Do not subject the remote control to undue physical stress, such as striking or dropping it. Do not attempt to clean the remote control with a volatile solvent. Wipe it with a clean, damp cloth. Cleaning the Housing and Remote Control If the housing or remote control is seriously contaminated, use a soft cloth moistened with diluted neutral cleaner to clean the display. Wring water out of the cloth before cleaning to prevent water from penetrating into the housing. Wipe with a dry cloth after cleaning. Changing Volume Lock (when using a VIZIO Universal remote with the Sound Bar) VIZIO Universal remotes are normally set to control the volume of the TV, even when one of the other programmable devices is selected. The remote control can be set to control the device volume, the Sound Bar in this case, by changing the Volume Lock. To change the volume lock: 1. Press and release the AUDIO button. 2. Press and hold the SETUP button until the LED on the remote flashes twice. 3. Press 9 9 3. The LED flashes twice. 4. Press VOL - The LED flashes four times. The Sound Bar volume will now be controlled using VOL+/VOL- while in the AUDIO device mode, and the TV, Cable/Satellite or DVD volume when in TV, Cable or DVD modes. 10 www.VIZIO.com