Vizio VSB200 VSB200 User Manual - Page 21

Audio Adjustments Input - Pressing this button on the Remote Control or on the Sound Bar will sequence the input selection through Analog1, Analog 2 and Optical. Vol+ - Pressing this button on the Remote Control or on the Sound Bar will increase the volume level. Hold for one-half second to continuously increase volume Vol - - Pressing this button on the Remote Control or on the Sound Bar will decrease the volume level. Hold for one-half second to continuously decrease volume Mute - Pressing this button on the Remote Control or on the Sound Bar will either mute or un-mute the Sound Bar. TVOL - When the programming switches to a commercial or when changing from channel to channel, volume fluctuations occur. This SRS TruVolumeTM provides the listener with a comfortable and consistent volume level. Pressing this button on the Remote Control or on the Sound Bar will set the HD Sound Bar to have control over the level of the audio output, preventing commercials on regular programming to become louder than the volume of the program being viewed. Pressing this button will toggle SRS TruVolume ON and OFF. TSHD - Pressing this button on the Remote Control or on the Sound Bar will toggle SRS TruSurround HD ON and OFF. Chapter 6 Error Detection / Corrective Action If an unsupported rate or sample depth is detected (via the Optical Input), or an overcurrent or thermal shutdown occurs, the LED's flash certain error codes. An important example that if an AC3 (not PCM) input stream(from a DVD player in this instance) is sent to the Optical input, the HD Sound Bar will mute the audio output and flash the error pattern associated with this on the LED's. For the error codes, the information is relative to the position in the volume bar section of the display. (LED positions as viewed from the front): ABCDE FG The following is a description of the LED error codes: A = SPDIF compressed format detected. B = SPDIF rate unsupported. C = Overcurrent error occurred. D = Thermal shutdown occurred. The other indicators are not currently used for error indication. When an error occurs, the volume strip goes on solid except that the active error condition is flashing. Corrective Action - If Error A, SPDIF compressed format detected error occurs, configure the DVD player (or audio source device) audio output format setting to PCM or PCM stream. Otherwise, use the Analog RCA inputs from the audio source to the Sound Bar without configuration of the audio source device. Version 7/16/2009 21 www.VIZIO.com