Vtech 59234 User Manual - Page 2

TABLE/DESK INSTALLATION This telephone includes a 7-foot line cord with a modular plug on each end. Use this cord to connect the telephone to a modular jack. 1 Fill in directory card Remove the directory card and write in your own telephone number. Also write the telephone numbers (or names) that you want to store in each memory location. Reinstall the card and clear plastic cover. 2 Connect line cord to telephone Plug the long line cord into the Figure 1 jack on the underside of the telephone base. Then feed the line cord through the channel provided so the telephone sits flat on your table or desk during use (Figure 1). 3 Connect line cord to wall jack Plug free end of the line cord into a modular jack. Make sure it snaps firmly into place. 4 Set DIAL mode switch This product comes set in the tone (TT) mode. Make sure Figure 2 you choose the correct dialing method (TT or DP); touch tone dialing will not work if you have dial pulse service. 5 Connect handset to base Plug one end of the coiled handset cord into the handset, and the other end into the base. Then hang up. 6 Check for dial tone Lift the handset and listen for dial tone. If you cannot hear a dial tone, refer to "In Case of Difficulty" and try to correct the problem. TO DISCONNECT the telephone, squeeze the clip on the modular plug and pull it out of the jack. 1