Vtech 59234 User Manual - Page 4
in Table/Desk Installation.
UPC - 650530930201
View all Vtech 59234 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
4 Install telephone base on wall jack Hold the base up next to the wall jack, and plug in the line cord (Figure 3). Then push the base against the wall jack and down until it is held securely by the mounting studs. MEM 1 MEM 2 MEM 3 MEM 4 MEM 5 MEM 6 MEM 7 MEM 8 MEM 9 THIS NO. NOTE: If you cannot fit the base onto the wall jack, remove the four non-slip pads. Figure 3 5 Set DIAL mode switch Refer to Step 4 in "Table/Desk Installation." 6 Connect handset to telephone Connect one end of the coiled handset cord into the base. Plug the other end into the handset (Figure 4). Then hang up. MEM 2 MEM 3 MEM 4 MEM 5 ME MEM 9 THIS NO. Figure 4 7 Check for dial tone Lift the handset and listen for dial tone. If you cannot hear a dial tone, refer to "In Case of Difficulty" and try to correct the problem. 3