Vtech Five Handset Expandable Cordless Phone System with Digtial Answering Syste - Page 41

Page 41 highlights

Appendix Replace a handset If you want to replace a handset or reassign the designated handset number of a registered handset, you must de-register all the handsets and then individually register each handset. To make de-registration easier, read all of the instructions on this page before you begin. To de-register all handsets: 1. Press and hold /FIND HANDSET on the telephone base for about 10 seconds (until the IN USE light on the telephone base turns on and starts to flash), then release /FIND HANDSET. 2. Press /FIND HANDSET again. You must press /FIND HANDSET while the IN USE light is still flashing. The IN USE light flashes for approximately seven seconds. 3. All system handsets show CONNECTING... The de-registration process takes about 10 seconds to complete. All handsets show NOT REGISTERED when the de-registration completes. If de-registration fails, you might need to reset the telephone and try again. To reset: 1. Pick up the registered handset and then press . 2. Press OFF/CLEAR and place the handset back in the telephone base. -OR1. Unplug the power from the telephone base, then plug it back in. You cannot de-register a handset if any system handset is in use. 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
37
Appendix
Replace a handset
If you want to replace a handset or reassign the designated handset number
of a registered handset, you must de-register all the handsets and then
individually register each handset.
To make de-registration easier, read all of the instructions on this page before
you begin. To de-register all handsets:
Press and hold
/FIND HANDSET
on the telephone base for about 10
seconds (until the
IN USE
light on the telephone base turns on and starts
to flash), then release
/FIND HANDSET
.
Press
/
FIND HANDSET
again. You must press
/
FIND HANDSET
while
the
IN USE
light is still flashing. The
IN USE
light flashes for approximately
seven seconds.
All system handsets show
CONNECTING...
The de-registration process
takes about 10 seconds to complete. All handsets show
NOT REGISTERED
when the de-registration completes.
If de-registration fails, you might need to reset the telephone and try again.
To reset:
Pick up the registered handset and then press
.
Press
OFF/
CLEAR
and place the handset back in the telephone base.
-OR-
Unplug the power from the telephone base, then plug it back in.
1.
2.
3.
1.
2.
1.
You cannot de-register a handset if any system handset is in use.