Vtech VT4121 User Manual - Page 11

INSTALLATION d. Insert one end of the handset cord into the handset and the other end into the left side of the telephone. Place the handset in the telephone cradle. e. Plug the two long line cords into the wall jacks. Double check that you have not reversed the L1/L2 and L3/L4 cord connections. f. Plug the AC power cord adaptor into a standard 120V AC wall outlet. The display shows "Check Clock & ID ". Refer to the programming section to program the clock and change the extension ID. g. Ensure that all cords are positioned to prevent tripping and rubbing which could create a potential electrical hazard. the wall. 1. Insert the two (2) screws and anchoring devices into the wall 3-5/8 inches apart vertically, allowing approximately 3/16 inch between the wall and screw heads for mounting the telephone. Ensure that the screws are secure. 2. Turn the speakerphone over to view the bottom. 2.2 Wall Mounting You will want to ensure the following: • The location where the telephone will be mounted should be away from electrical cables, pipes, or other items which may be punctured when the screws are inserted into the wall. • The wall surface should be capable of supporting the telephone weight. 3. If you have already installed the desk/wall mount bracket in desk mode, please remove the desk/ wall mount bracket by gently moving one tab at a time while pulling the peg out of the tab hole. 4. Rotate the bracket and install it in the wall mounting position by aligning the four holes on the bracket with the four hooks on the bottom of the telephone. • Use the screws and anchoring devices provided with the telephone. • The telephone is located near an AC outlet. Two (2) long line cords are provide to meet various wall mounting conditions. A template is provided at the back of this manual to assist you with the installation of the telephone directly onto 11