Waring WDM360 Instruction Manual - Page 4

The drink mixer can be operated without engaging the ON/OFF cup actuator by using the PULSE toggle switch. The Pulse switch will operate at whatever speed the 3-speed switch is set to. The PULSE switch will only operate while pressed forward or backwards. Keep a firm grip on the cup while using PULSE . Your Waring® Drink Mixer is supplied with 6 agitators, 3 standard and 3 "butterfly" (with the movable flaps). To switch agitators, simply hold the spindle shaft with one hand and turn the agitator in a clockwise direction. This will loosen the screw, and you can unscrew to remove. Insert replacement agitator and screw bottom screw back in. Tighten by turning the agitator in a counterclockwise direction. Use only standard metal mixing cups with the drink mixer. CLEANING & SANITIZING INSTRUCTIONS 1. Rinse container thoroughly under running water. Add 8 ounces of clean rinse water to container. Place container in normal operating position on mixer and run on high speed for two (2) minutes. Empty container. Repeat process for all spindles. 2. UNPLUG MIXER POWER CORD FROM ELECTRICAL OUTLET. 3. To remove bottom cup supports (C), simply push each support up, then pull out. 4. To remove the upper cup holders (D), hold the notches on both sides of the holder, then pull directly out from the base. 5. Wash, rinse, and sanitize the container supports, upper cup holder and container. Sanitize these parts by immersing in sanitizing solution for two (2) minutes. Shake off excess moisture and allow parts to air dry. 4