Waring WDM500 Instruction Manual - Page 3

Introduction, Operation

Page 3 highlights

If a grounding-type outlet is not available, an adapter, shown in Figure 2, may be obtained to enable a 2-slot wall outlet to be used with a 3-prong plug. As shown in Figure 3, the adapter must be grounded by attaching its grounding lug under the screw of the outlet cover plate. CAUTION: Before using an adapter, it must be determined that the outlet cover plate screw is properly grounded. If in doubt, consult a licensed electrician. Never use an adapter unless you are sure it is properly grounded. NOTE: Use of an adapter is not permitted in Canada. INTRODUCTION The Waring® Commercial Big Freeze™ drink mixer is designed specifically to process thick, ice cream-based mixtures in standard milk shake cups, utilizing a powerful and quiet, directdrive motor without noise-producing gears or belts. OPERATION Manual Operation 1. Be sure clear plastic splash shield is in position and slides up and down freely. 2.  Plug power cord into properly grounded electrical outlet of correct voltage. 3. Set toggle switch to "ON" position. 4. Allow motor to reach full speed (1-2 seconds). 5. Bring mixing cup up into position under rotating agitator. 6. Lift cup upward in one slow continuous motion until agitator bottoms out, then lower cup back down slowly until agitator begins to emerge. Withdraw cup from spindle slowly enough 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

3
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained to enable a 2-slot wall outlet to be
used with a 3-prong plug.
As shown in Figure 3, the adapter must be grounded by attaching
its grounding lug under the screw of the outlet cover plate.
CAUTION: Before using an adapter, it must be determined that
the outlet cover plate screw is properly grounded. If in doubt,
consult a licensed electrician.
Never use an adapter unless you are sure it is properly grounded.
NOTE: Use of an adapter is not permitted in Canada.
INTRODUCTION
The Waring
®
Commercial Big Freeze
drink mixer is designed
specifically to process thick, ice cream-based mixtures in
standard milk shake cups, utilizing a powerful and quiet, direct-
drive motor without noise-producing gears or belts.
OPERATION
Manual Operation
1.
Be sure clear plastic splash shield is in position and slides
up and down freely.
2.
Plug power cord into properly grounded electrical outlet of
correct voltage.
3.
Set toggle switch to “ON” position.
4.
Allow motor to reach full speed (1–2 seconds).
5.
Bring mixing cup up into position under rotating agitator.
6.
Lift cup upward in one slow continuous motion until agitator
bottoms out, then lower cup back down slowly until agitator
begins to emerge. Withdraw cup from spindle slowly enough