Waring WWB10G Instruction Manual - Page 14

TROUBLESHOOTING CODES During operation under certain conditions, your machine may display one of the following error codes. Please follow the chart below to fix. Error Code Cause Solution Contact a Service Center if the following error codes appear E-1 Internal temperature control Call a service center for repair or damage. adjustment. E-2 Machine malfunction. Call a service center for repair or adjustment. E-3 Heating element damage. Call a service center for repair or adjustment. E-4 Issue with upper water level Call a service center for repair or sensor. adjustment. E-5 Issue with lower water level Call a service center for repair or sensor. adjustment. User Fixable E-6 Hot water dispenser does not Connect to a water source or switch have enough water to begin to manual mode and pour water heating. into the hot water dispenser. Once water is at proper fill level, alarm will stop and the machine will begin heating. E-7 Water level is too low Ensure hot water dispenser is on a level surface. Ensure the connection to the water supply is open and water line pressure is running properly. If the problem persists, consult customer service or a local service center. E-8 Power outage or issue with Disconnect plug and reconnect power source. to outlet. Ensure plug is properly inserted into outlet. Check circuit breaker and reset. If the problem persists, consult customer service or a local service center. E-9 Water has exceeded max fill. Shut off the water supply, drain excess water. Alarm should go off. If problem persists, contact a service center. If this Error is seen in manual mode, dispense some water from the spigot. 14