Waring WWB10G Instruction Manual - Page 4
Introduction, Grounding Instructions
View all Waring WWB10G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INTRODUCTION Thank you for purchasing this WaringTM Commercial Hot Water Dispenser. Features & Benefits • Hot water dispenser can be plumbed into a water connection or it can be manually filled for multiple location and off-site use. • Night Mode feature conserves energy and ensures hot water is ready when you need. • Fill rate: approximately 1 gallon per minute when unit is plumbed-in • Initial heat-up time to full capacity: approximately 3 hours (assuming water is at 75°F (23°C) to start) • Hot water dispenser will maintain set water temperature within +/- 5°F • Safety Features • Tomlinson® No-Drip® tap operation* • Excess water drain: Easily and safely removes excess water from below spigot level. • Knuckle guard: Protects hand from hot surface. • Low water level sensor: In case water level gets low, an alarm will sound and the heater will automatically be shut off. This protects your machine. Once the issue is corrected/more water added, the alarm will stop. • High-level water sensor: If water level gets too high, an alarm will sound and the heater will automatically be shut off. GROUNDING INSTRUCTIONS For your protection, the WaringTM Commercial Hot Water Dispenser is equipped with a 3-conductor cord set that has a molded 3-prong grounding-type plug, and should be used in combination with a properly connected grounding-type outlet as shown in Figure 1. If a grounding-type outlet is not available, an adapter, shown in Figure 2, may be obtained so that a 2-slot wall outlet can be used with a 3-prong plug. Referring to Figure 3, the adapter must be grounded by attaching its grounding lug under the screw of the outlet cover plate. * Tomlinson®, No-Drip® and the Faucet and Handle configurations are registered trademarks of The Meyer Company, Cleveland, Ohio. 4