Weber Platinum II 2200 LP Owner Manual - Page 13

MAINTENANCE h) Lift and twist the burner assembly slightly, to separate the crossover tube from the burners. Figure 13. Remove the burners from the cooking box. Crossover tube j) Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the Venturi fins. There should be no gaps in the seams or in the fit around the burners and valves. Figure 15. Figure 13 i) To reinstall the burners, reverse steps c) through h). CAUTION: The burner openings must be positioned properly over the valve orifices. Figure 14 (a). Check proper assembly before fastening manifold in place. Figure 14 (b). (a) Valve Venturi fin Check fit around valve Check fit around burner Figure 15 CAUTION: If the Spider Stopper Guards do not fit tightly, contact Weber-Stephen Customer Service. CAUTION: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue. Burner (b) Figure 14 Crossover Ignition System Operations If the Crossover Ignition System fails to ignite the Front burner, light the Front burner with a match. If the Front burner lights with a match, then check the Crossover Ignition System. s Check that both the white and black ignition wires are attached properly. Figure 16. s Check that the Crossover Ignition button pushes the igniter (button) down, and returns to the up position. s Check to see if the igniter is loose in the frame. Tighten if necessary; See "Check That Items Are Secured" in the Step-By-Step Guide for correct procedure. If the Crossover Ignition System still fails to light, contact Weber-Stephen Customer Service. White wire Black wire 13 Figure 16