Weber Platinum II 3200 NG Owner Manual - Page 12

Step 7 Install side burner locks You will need: frame assembly, two side burner locks and a 7/16 inch wrench. Loosen the right rear 1/4 x 20 bolt. Install the side burner lock. The "U" shape cut out of the lock slips down over the bolt. Tighten with a wrench. Figure 6 (a). Loosen the right front 1/4 x 20 bolt. The side burner lock fits between the front panel and the frame. The "U" shape cut out slips up over the bolt. Tighten with a wrench. Figure 6 (b). Step 8 Add cooking box You will need: frame assembly, cooking box assembly, spacer bracket, 1/4-20 x 2 inch bolt, nylon washer, 1/4-20 keps nut, pliers and a 7/16 inch wrench. Set the cooking box into the frame so the burner tubes are under the frame brace. Figure 7. Burner tubes Frame brace Figure 6 Figure 7 Slide the cooking box to the left within the frame. Put the washer on the bolt. Take the spacer bracket and hold it up to the frame making sure both tabs fit underneath the frame cross piece. Figure 8 (a). Insert the bolt through the center hole in the spacer bracket, frame and cooking box with the head of the bolt outside the spacer bracket. Figure 8 (b). Add the keps nut. Figure 8. Tighten by holding the bolt with pliers while you tighten the nut with a wrench. Frame cross piece Spacer bracket Keps nut (b) (a) Bolt Nylon washer Figure 8 12