Weber Platinum II 3200 NG Owner Manual - Page 22

Insert one end of the hinge rod into the hole in the frame. Figure 32 (a). Insert the other end into the hole in the swing table end bracket. Figure 32 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 32 (c). To fully seat the bracket, you may have to tap it lightly with a hammer. ƽWARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call your dealer to order a new part. ƽWARNING: The load limit for the swing table is 30 pounds. (a) (b) Position slide bar assembly on the outside of the wheel frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through wheel frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 33. Notch F Slide bar View from front of barbecue Wheel frame Figure 33 View from rear of barbecue Hinge rod To lower table: Pull support rod up to disengage slide lock and lower table. To raise table, lift table up and engage slide in locked position. Figure 34. Support rod (c) Slot in frame (view from below) Figure 32 Slide Unlocked position Locked position Figure 34 22