Weber Platinum II 3200 NG Owner Manual - Page 23

Complete accessory installation

Page 23 highlights

Step 23 Complete accessory installation You will need: work table, two accessory trays, Warm-Up Basket, warming rack, thermometer, two tubing plugs and a hammer. Insert one end of the Weber Warm-Up Basket into the hole in the right end of the lid and the other end into the slot in the left end of the lid. Figure 35 (a). Set the work table onto the left side rails. Figure 35 (b). Set the accessory trays between the two frame connectors. Figure 35 (c). Set the warming rack into the slots at the rear of the cooking box. Figure 35 (d). Insert the thermometer into its holder. Figure 35 (e). Insert tubing plugs into the ends of the frame. To fully seat the plugs, you may have to tap them lightly with a hammer. Figure 35 (f). (a) (d) (e) (b) (c) (f) Figure 35 ƽCAUTION: To keep the barbecue stationary, the tabs on the locking casters should be in the down position. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

23
Step 23
Complete accessory installation
You will need: work table, two accessory trays, Warm-Up
Basket, warming rack, thermometer, two tubing plugs and
a hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 35 (a).
Set the work table onto the left side rails. Figure 35 (b).
Set the accessory trays between the two frame connectors.
Figure 35 (c).
Set the warming rack into the slots at the rear of the
cooking box. Figure 35 (d).
Insert the thermometer into its holder. Figure 35 (e).
Insert tubing plugs into the ends of the frame. To fully seat
the plugs, you may have to tap them lightly with a hammer.
Figure 35 (f).
Figure 35
(a)
(d)
(e)
(f)
(b)
(c)
m
CAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.