Weider 146 English Manual - Page 8

7. Lubricate the M10 x 70mm Bolt (26). Attach the Leg Lever (4) to the bracket (C) on the Front Leg (8) with the Bolt, two M10 Washers (22) and an M10 Nylon Locknut (21). Do not tighten the Nylon Locknut; the Leg Lever must be easy to turn. Attach the Leg Lever Lock (36) to the Front Leg (8) with an M8 x 51mm Bolt (39), an M8 Washer (20) and an M8 Nylon Locknut (33). Do not tighten the Nylon Locknut; the Leg Lever Lock must be easy to turn. 8. Press two 19mm Round Inner Caps (14) into each Short Pad Tube (10). Press two 19mm Round Inner Caps into the Long Pad Tube (35). Insert the Short Pad Tubes (10) into the holes in the Leg Lever (4). Slide two Foam Pads (34) onto each Pad Tube. Insert the Long Pad Tube (35) into the holes in the bracket (C) on the Front Leg (8). Slide a Foam Pad (34) onto each end of the Long Pad Tube. 9. Press a 1Ó Square Inner Cap (13) into the indicated end of each Backrest Tube (5). Attach each Backrest Tube (5) to the Backrest (6) with two M8 x 40mm Bolts (25) and two M8 Washers (20). The indicated holes in the Backrest Tubes must be oriented as shown. Do not tighten the four Bolts yet. 7 22 C 21 4 33 8 22 26 Lubricate 20 39 36 8 34 35 34 14 C 14 10 14 14 34 34 4 8 9 13 25 20 5 25 20 6 Holes 10. Press a 1Ó Square Inner Cap (13) into each end of 10 the Support Tube (7). Set the Support Tube into the 13 7 highest set of adjustment brackets (D) on the Uprights (1, 16). Lubricate the M10 x 130mm Bolt (9). Attach the D 13 1 Backrest Tubes (5) to the Frame (2) with the Bolt, two M10 Washers (22) and an M10 Nylon Locknut (21). Do not overtighten the Nylon Locknut. Rest the Backrest (6) on the Support Tube (7). 9 22 5 6 16 Tighten the four Bolts (25) used in step 9. Lubricate 2 22 21 8