Weider 8225 Hard Drive English Manual - Page 16
positions.
View all Weider 8225 Hard Drive manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
ADJUSTING THE BACKREST The Large Backrest (30) can be adjusted to any of three positions. To change the position, first remove the 5/16" Knob (11) and 5/16" x 2 3/4" Carriage Bolt (113). Pivot the lower end of the Large Backrest until one of the three holes in the Adjustment Bracket (22) is aligned with the hole in the Front Upright (19). Insert the Carriage Bolt through the Adjustment Bracket and the Front Upright, and tighten the Knob onto the Carriage Bolt. ATTACHING AND REMOVING THE SEAT The Seat (31) should be attached to the Front Upright (19) as described in assembly step 21 on page 11. For some exercises, the Seat must be removed. To remove the Seat, first make sure that the chain is not attached to the leg lever. Next, remove the 5/16" Knob (11) and 5/16" x 2 3/4" Carriage Bolt (113) from the Seat Frame (32). Lift the Seat off the Front Upright. ATTACHING THE LEG LEVER TO THE LOW PULLEY STATION To use the Leg Lever (33), the Seat (31) must be attached to the Front Upright (19) (see ATTACHING AND REMOVING THE SEAT above). Attach one end of the Chain (73) to the Pulley Cable (69) with a Cable Clip (74). Attach the other end of the Chain to the 5/16" x 2" Eyebolt (37) with a Cable Clip. ATTACHING THE LAT BAR OR NYLON STRAP TO THE HIGH PULLEY STATION Attach the Lat Bar (72) to the Pulley Cable (69) with a Cable Clip (74). For some exercises, the Chain (73) should be attached between the Lat Bar and the Pulley Cable with two Cable Clips. Adjust the length of the Chain between the Lat Bar and the Pulley Cable so the Lat Bar is in the correct starting position for the exercise to be performed. The Nylon Strap (125) can be attached in the same manner. 16 30 19 11 O 113 22 O 31 19 0 0° 11 113 O 32 31 O° 19 37 73 69 74 0 33 O 74 73 69 74 72 74 125