Weider 8225 Hard Drive English Manual - Page 18
Trouble, Shooting, Maintenance
View all Weider 8225 Hard Drive manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts each time you use the hard drive system. Replace any worn parts immediately. The hard drive system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable used on the hard drive system, can stretch slightly when it is first used. If there is any slack in the cables before resistance is felt, the cables should be tightened as described below. When the Weight Cable (70) is properly tightened, the pivot arm (see the drawing on page 19) should be resting against the stop bolt. To tighten the Weight 70 Cable, first remove the 5/16" x 1 1/4" Bolt (2), the Weight Bracket (110) and the 1/2" x 1/2" Spacer (117). Remove the Cable Bracket (56) from the Weight Tube (108). Tighten the 1/4" Nut (46) farther 56 108 e--46 onto the end of the Weight Cable. Insert the Cable Bracket back onto the Weight Tube. Reattach the 5/16" x 1 1/4" Bolt (2), the Weight Bracket (110) and Pc the 1/2" x 1/2" Spacer (117). To further tighten the Weight Cable, the Bolt can be tightened into the 2 107 upper hole in the Cable Bracket rather than the lower hole. Make sure that the Weight Cable is not too tight, or the first weight (107) will be lifted off the weight stack To tighten the Pulley Cable (69), first loosen the adjustment screw near the lower end of the Pulley Cable. Pull the end of the Pulley Cable until the Pulley Cable is tight, and slide the adjustment sleeve and the ball against the 2 5/8" Pulley (123). Retighten 123 0 the adjustment screw. If the weight cable or pulley cable need to be replaced, see the back cover of this owner's manual for information about ordering replacement parts. Adjustment Screw 0 69 Adjustment Ball Sleeve 18