Weider 8630 Training Canadian English Manual - Page 12

20. Wrap the Butterfly Cable (89) around a 90mm 20 Pulley (82) as shown. Attach the Pulley and a Cable Trap (80) to the bracket on the Leg Press Upright (4) with an M10 x 48mm Bolt (50) and an M10 Nylon Locknut (42). The Cable Trap must be oriented to hold the Cable in the groove of the Pulley. 21. Wrap the Butterfly Cable (89) under a 90mm Pulley (82). Attach the Pulley and a Cable Trap 21 (80) between the single hole ends of two Pulley Plates (31) with an M10 x 48mm Bolt (50) and the M10 Nylon Locknut (42). Make sure that the Cable Trap is positioned to hold the Cable in place. 22. Wrap the Butterfly Cable (89) over a 90mm Pulley (82) as shown. Attach the Pulley and a Cable 22 Trap (80) to the other side of the bracket on the Leg Press Upright (4) with an M10 x 48mm Bolt (50) and an M10 Nylon Locknut (42). The Cable Trap must be oriented to hold the Cable in the groove of the Pulley. 82 50 80 42 4 89 89 42 82 80 31 50 End with two holes should be down 80 50 42 82 89 4 23. Note: The Left Fly Arm (6) is shown removed for easier part identification. 23 Attach the Butterfly Cable (89) to the Left Fly Arm (6) with an M8 x 22mm Shoulder Bolt (51) and an M8 Nylon Locknut (40). Make sure the flat edge of the Cable is against the Fly Arm. 51 89 40 6 Flat Edge 12