Weider 8950 Uk Manual - Page 10
Locate the Press Cable 49.
View all Weider 8950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
14. Wrap the High Cable (50) over a 90mm Pulley 14 (34). Attach the Pulley and a pair of Pulley Covers (35) to the bracket on the Top Frame (4) with an M10 x 52mm Bolt (52) and an M10 Nylon Locknut (68). Make sure the small tabs on the Pulley Covers are on bottom. 15. Attach the end of the High Cable (50) to the 15 Small "U"-bracket (11) with an M8 Washer (71) and an M8 Nylon Locknut (69). Note: Do not completely tighten the Locknut; it should be 71 threaded onto the Cable so that two threads show past the Locknut, as shown in the inset 69 drawing. Attach the Small "U"-bracket (11) to the Weight Tube (12) with an M8 x 45mm Bolt (60) and an M8 Nylon Locknut (69). Do not overtighten the Locknut; the Weight Tube must be able to pivot in the Small "U"-bracket. 16. Locate the Press Cable (49). Slide the Cable 16 onto the hook on the Left Arm (7). 52 4 68 34 35 35 50 60 11 12 50 69 17. Attach the Pulley Arm (38) to the Upright (3) with 17 an M10 x 78mm Bolt (54) and an M10 Nylon Locknut (68). Do not overtighten the Locknut; the Pulley Arm must be able to pivot easily. Wrap the Press Cable (49) over a 90mm Pulley (34). Attach the Pulley and a pair of Pulley Covers (35) to the indicated side of a Pulley Arm (38) with an M10 x 52mm Bolt (52) and an M10 Nylon Locknut (68). Make sure the large tabs on the Pulley Covers are in the indicated position. 10 49 Hook 7 3 54 35 38 52 68 34 Large 49 Tab