Weider Club 500 English Manual - Page 13
Tighten all of the M10 Nylon Locknuts 32
View all Weider Club 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
24. Route the Cable (79) through the Lat Tower Base 24 (49) and around an 89mm Pulley (65). Attach the Pulley to the bracket on the Lat Tower Base with an M10 x 45mm Bolt (27) and an M10 Nylon Locknut (32). 79 32 65 27 49 25. Route the Cable (79) under an 89mm Pulley (65) and through the Foot Plate (57) as shown. Attach the Pulley to the Foot Plate with an M10 x 45mm Bolt (27) and an M10 Nylon Locknut (32). Attach the Foot Plate (57) to the Lat Tower Base (49) with two M10 x 19mm Bolts (72) and two M10 Nylon Locknuts (32). Attach the Foot Plate (57) to the Front Crossbar (43) with two M10 x 94mm Bolts (18), two M10 Washers (74), and two M10 Nylon Locknuts (32). Tighten all of the M10 Nylon Locknuts (32) used in steps 12-18. 26. Press two 51mm Round Inner Caps (23) into two Storage Tubes (70). Screw the Storage Tubes onto the Left Rear Upright (46). Make sure the Storage Tubes are fully tightened. Repeat this step with the other two Storage Tubes (70) and the Right Rear Upright (not shown). 25 43 74 32 27 18 79 72 26 65 32 32 49 57 74 32 32 70 23 46 70 23 27. Press a 38mm Round Inner Cap (68) into the end 27 of the Left Weight Rest (80). Press a 38mm Round Inner Cap into the Left Safety Spotter (81). Insert the Left Weight Rest (80) and the Left 68 80 Safety Spotter (81) into holes in the left Front Upright (44) and engage the locking pins around the Upright. 44 68 81 Repeat this step with the Right Weight Rest (not shown), the Right Safety Spotter (not shown), and the right Front Upright (not shown). 13