Weider Core 600 Bench English Manual - Page 8
Tubes 21 and the Leg Lever 5. - press
View all Weider Core 600 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
6. Apply a portion of the included grease to an 6 M10 x 165mm Bolt (50). Attach the Backrest Frames (16) to the Frame (1) with the Bolt, two M10 Washers (55), and an M10 Nylon Locknut (42). Set the end of the Backrest Post (15) in one of the slots in the Frame. Do not over- tighten the Nylon Locknut; the Backrest Frames must pivot easily. See step 5. Tighten the M10 Nylon Locknut (42) and the four M6 x 40mm Screws (51). Do not overtighten the Nylon Locknut; the Backrest Post (15) must pivot easily. 42 55 16 15 55 Grease 50 Slot 1 7. Attach the Weight Tube (24) to the Leg Lever 7 (5) with an M8 x 70mm Bolt (46), a Weight Tube Spacer (41), two M8 Washers (49), and an M8 Nylon Locknut (36). Then, press a 25mm Round Outer Cap (29) onto the Weight Tube. Bracket 47 Grease Apply grease to the barrel of an M10 x 77mm 36 49 4 Bolt Set (47). Attach the Leg Lever (5) to the Front Leg (4) with the Bolt Set. Make sure that 5 29 47 the barrel of the Bolt Set is inserted through 41 both sides of the bracket on the Front Leg. 24 49 46 8. Insert the Long Pad Tube (56) into the bracket on the Front Leg (4). Slide two Foam Pads (22) onto the Pad Tube, and then press two Pad Caps (23) into the Foam Pads. Repeat this step with the two Short Pad Tubes (21) and the Leg Lever (5). 8 23 22 5 56 4 21 21 Bracket 22 23 8