Weider Pro 125 Bench Uk Manual - Page 7

6. Note that the bracket on the Backrest Frame (4) has four sets of oval holes and one set of round 6 holes. Hold the 15mm x 10mm x 67mm Spacer (28) between the round holes in the bracket. Insert 29 an M10 x 88mm Bolt (29) through the bracket and the Spacer. Tighten an M10 Nylon Locknut (18) 16 onto the Bolt. Make sure that the Spacer is under 4 Round the Main Frame (1). Hole Insert the Locking Pin (16) through one of the four sets of oval holes in the bracket on the Backrest Frame (4) and through the welded tube in the Main Frame (1) (the welded tube is shown in drawing 5). Oval Adjustment Holes 1 18 28 7. Attach the Backrest (8) to the brackets on the Backrest Frame (4) with four M6 x 16mm Screws 7 (15). 8 4 8. Attach a 30mm x 25mm Bumper (26) to the indicated hole in the Main Frame (1) with a Bumper Screw (25). Press a 25mm x 50mm Inner Cap (14) into each end of the Seat Frame (5). Note that the Seat Frame (5) has two welded tubes. "tube A" passes through the Seat Frame and "tube B" is welded beneath the Seat Frame. Do not confuse the two tubes in this step. Align tube A in the Seat Frame (5) with the upper hole in the indicated bracket on the Main Frame (1). Attach the Seat Frame to the Main Frame with the M10 x 95mm Bolt (20) and an M10 Nylon Locknut (18). Do not overtighten the Nylon Locknut; the Seat Frame must pivot easily. Insert the Locking Pin w/Ring (30) through tube B to prevent the Seat Frame (5) from pivoting. 7 15 8 20 Welded Tube A 30 5 14 26 25 15 14 Welded Tube B 18 Bracket 1