Weider Pro 2250 English Manual - Page 12

21. Insert the M6 x 50mm Carriage Bolt (38) into the center hole in the Seat Plate (37). Attach the Seat 21 Plate to the Seat (13) with two M6 x 16mm Screws (18). Insert the M6 x 50mm Carriage Bolt (38) into the indicated hole in the Seat Frame (36). Tighten an M6 Nylon Locknut (2) with an M6 Washer (10) onto the Carriage Bolt. Attach the other end of the Seat (13) to the Seat Frame (36) with an M6 Washer (10) and an M6 x 50mm Screw (24). 38 37 18 13 36 10 24 2 22. Lubricate the M8 x 57mm Bolt (80) with grease. Attach the Leg Lever (29) to the Seat Frame (36) with the Bolt and an M8 Nylon Locknut (3). Make sure the decal is in the indicated position. Do not overtighten the Locknut; the Leg Lever must be able to pivot freely. Insert a Eyebolt (35) into the Leg Lever (29) from the direction shown. Tighten an M10 Nylon Locknut (21) and an M10 Washer (9) onto the Eyebolt. 22 Lubricate 80 29 Decal 9 21 3 36 35 23. Insert a Pad Tube (28) into the Seat Frame (36). 23 Wet the Pad Tube with soapy water. Slide two Small Pads (30) onto the Pad Tube. Assemble the other Pad Tube (28) to the Leg Lever (29) in the same manner. 30 29 36 28 30 24. Rest the Seat Frame (36) on the indicated pin in 24 the Front Upright (42). Attach the Seat Frame to the Front Upright with an M8 x 67mm Carriage Bolt (86) and the Seat Knob (40). 28 40 36 86 42 Pin 12