Weider Pro 2250 English Manual - Page 6
Tighten the M10 Nylon Locknuts 21 used - system
View all Weider Pro 2250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2. Slide the Front Upright (42) onto the M8 x 65mm Carriage Bolts (1) in the Base (4). Hand tighten 2 two M8 Nylon Locknuts (3) onto the Carriage Bolts. Do not tighten the Locknuts yet. 42 3 3. Attach the two Weight Guides (62) inside of the 3 Stabilizer (5) with two M10 x 67mm Bolts (11), two M10 Washers (9), two 13mm Spacers (61), and two M10 Nylon Locknuts (21). Tighten the M10 Nylon Locknuts (21) used in step 1. Slide two Weight Bumpers (19) onto Weight Guides (62). Stack the six Weights (25) on the Weight Bumpers (19). Make sure that all of the Weights are turned so the large pin grooves are on the bottom of the Weights and on the same side of the weight stack. Press the Weight Tube Bumper (64) into the end of the Weight Tube (63). Insert the Weight Tube into the stack of Weights (25). Make sure that the pins on the Weight Tube are resting in the pin grooves in the upper Weight. Lubricate the insides of the holes in the Top Weight (76). Slide the Top Weight onto the Weight Guides (62). 6 4 1 62 Lubricate Pin Pin Groove Pin Groove 19 21 76 63 64 25 9 11 9 61 5