Weider Pro 335 Bench English Manual - Page 8
the Right Barbell Lock Pin 17 to the Right Upright
![]() |
View all Weider Pro 335 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
6. Slide the Left Upright (42) onto the indicated M8 x 6 48mm Carriage Bolts (3). Hand-tighten an M8 Nylon Locknut (7) onto each Carriage Bolt. Be sure that the Upright is turned as shown. Do not tighten the Nylon Locknuts yet. Attach the Right Upright (43) in the same manner. Attach the Left Barbell Lock Pin (46) to the Left Upright (42) with an M8 Nylon Locknut (7). Attach the Right Barbell Lock Pin (17) to the Right Upright 46 (43) in the same manner. The Barbell Lock Pins must be oriented as shown. 7 42 7 17 7 43 7. Attach the Cross Brace (30) to the Lower Lat Tower (23) with two M8 x 50mm Bolts (1), two M8 Washers (2), and two M8 Nylon Locknuts (7). Attach the Cross Brace (30) to the Left Upright (42) with two M8 x 68mm Bolts (8), two M8 Washers (2), and two M8 Nylon Locknuts (7). Attach the Cross Brace (30) to the Right Upright (43) with two M8 x 68mm Bolts (8), two M8 Washers (2), and two M8 Nylon Locknuts (7). Tighten all M8 Nylon Locknuts (7) used in steps 1, 6, and 7. 8. Press a 1 1/2" Round Inner Cap (14) into each end of the Adjustment Tube (37). Set the Adjustment Tube (37) into one set of adjustment brackets on the Left and Right Uprights (42, 43). 3 7 23 42 2 8 7 2 43 8 2 7 1 7 30 8 Adjustment Brackets 37 14 42 14 43 8
![](/manual_guide/products/weider-pro-335-bench-english-manual-1e4897f/8.png)