Weider Pro 4000 Uk Manual - Page 14
Attach the Pulley and two Half Guards - cable
View all Weider Pro 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
25. Attach a 90mm Pulley (48) inside of the Front 25 Leg (7), over the Low Cable (53), with an M10 x 78mm Button Bolt (71), two M10 Washers (57), two 19mm Spacers (52), and an M10 Nylon Locknut (56). 57 56 33 48 7 53 57 33 71 26. Attach a 90mm Pulley (48) inside of the Upright 26 (3), over the Low Cable (53), with an M10 x 78mm Button Bolt (71), two M10 Washers (57), two 19mm Spacers (33), and an M10 Nylon Locknut (56). 56 33 57 48 53 3 57 33 71 27. Route the Low Cable (53) over a 90mm Pulley (48). Attach the Pulley and two Half Guards (43) to the Double "U"-bracket (63) with an M10 x 45mm Button Bolt (81) and an M10 Nylon Locknut (56). Make sure the Half Guards are on the outside of the Double "U"-bracket as shown. 27 56 43 53 28. Route the Low Cable (53) under a 90mm Pulley (48). Insert an M10 x 52mm Button Bolt (66) through two Half Guards (43), the Base (1), and the Pulley. Make sure the Half Guards are on the outside of the bracket as shown. 28 43 14 63 48 43 81 53 48 66 1 43